Follow
Srinath Ekkad
Srinath Ekkad
Department Head and RJ Reynolds Professor, NC State
Verified email at ncsu.edu
Title
Cited by
Cited by
Year
Gas turbine heat transfer and cooling technology
JC Han, S Dutta, S Ekkad
CRC press, 2012
30042012
Detailed heat transfer distributions in two-pass square channels with rib turbulators
SV Ekkad, JC Han
International Journal of Heat and Mass Transfer 40 (11), 2525-2537, 1997
4401997
A transient liquid crystal thermography technique for gas turbine heat transfer measurements
SV Ekkad, JC Han
Measurement Science and Technology 11 (7), 957, 2000
3312000
Film effectiveness over a flat surface with air and CO2 injection through compound angle holes using a transient liquid crystal image method
SV Ekkad, D Zapata, JC Han
Journal of Turbomachinery 119 (3), 587-593, 1997
2531997
A novel antivortex turbine film-cooling hole concept
JD Heidmann, S Ekkad
2522008
Detailed heat transfer distributions under an array of orthogonal impinging jets
Y Huang, SV Ekkad, JC Han
Journal of thermophysics and heat transfer 12 (1), 73-79, 1998
2491998
Effect of trench width and depth on film cooling from cylindrical holes embedded in trenches
Y Lu, A Dhungel, SV Ekkad, RS Bunker
2442009
Detailed heat transfer distributions in two-pass square channels with rib turbulators and bleed holes
SV Ekkad, Y Huang, JC Han
International journal of heat and mass transfer 41 (23), 3781-3791, 1998
225*1998
A transient infrared thermography method for simultaneous film cooling effectiveness and heat transfer coefficient measurements from a single test
SV Ekkad, S Ou, RB Rivir
J. Turbomach. 126 (4), 597-603, 2004
2182004
Jet impingement heat transfer on dimpled target surfaces
SV Ekkad, D Kontrovitz
International journal of heat and Fluid Flow 23 (1), 22-28, 2002
1852002
Detailed film cooling measurements on a cylindrical leading edge model: effect of free-stream turbulence and coolant density
SV Ekkad, JC Han, H Du
1741998
Heat Transfer Coefficients Over a Flat Surface with Air and CO2 Through Compound Angle Holes Using a Transient Liquid Crystal Image Method
JC Ekkad, S.V., Zapata, D., Han
Journal of Turbomachinery 119, 580-586, 1997
169*1997
Film cooling from a row of holes supplemented with antivortex holes
A Dhungel, Y Lu, W Phillips, SV Ekkad, J Heidmann
1552009
Recent development in turbine blade film cooling
JC Han, S Ekkad
International Journal of Rotating Machinery 7 (1), 21-40, 2001
1492001
A modern review on jet impingement heat transfer methods
SV Ekkad, P Singh
Journal of Heat Transfer 143 (6), 064001, 2021
1362021
Numerical investigation of turbulent flow and heat transfer in two-pass ribbed channels
BV Ravi, P Singh, SV Ekkad
International Journal of Thermal Sciences 112, 31-43, 2017
1312017
Effect of jet pulsation and duty cycle on film cooling from a single jet on a leading edge model
SV Ekkad, S Ou, RB Rivir
1292006
Experimental study of heat transfer augmentation in a two-pass channel featuring V-shaped ribs and cylindrical dimples
P Singh, S Ekkad
Applied Thermal Engineering 116, 205-216, 2017
1262017
Improved film cooling from cylindrical angled holes with triangular tabs: effect of tab orientations
H Nasir, S Acharya, S Ekkad
International Journal of heat and fluid flow 24 (5), 657-668, 2003
1262003
Impingement heat transfer on a target plate with film cooling holes
SV Ekkad, Y Huang, JC Han
Journal of Thermophysics and Heat transfer 13 (4), 522-528, 1999
1241999
The system can't perform the operation now. Try again later.
Articles 1–20