Volgen
Alfonso William Mauro
Alfonso William Mauro
Federico II Un. of Naples, Dept. of Industrial Engineering
Geverifieerd e-mailadres voor unina.it
Titel
Geciteerd door
Geciteerd door
Jaar
Flow pattern map, heat transfer and pressure drops during evaporation of R-1234ze (E) and R134a in a horizontal, circular smooth tube: Experiments and assessment of predictive …
S Grauso, R Mastrullo, AW Mauro, JR Thome, GP Vanoli
International journal of refrigeration 36 (2), 478-491, 2013
1362013
Fluid selection of Organic Rankine Cycle for low-temperature waste heat recovery based on thermal optimization
F Cataldo, R Mastrullo, AW Mauro, GP Vanoli
Energy 72, 159-167, 2014
1112014
Saturated critical heat flux in a multi-microchannel heat sink fed by a split flow system
AW Mauro, JR Thome, D Toto, GP Vanoli
Experimental Thermal and Fluid Science 34 (1), 81-92, 2010
842010
Flow pattern maps for convective boiling of CO2 and R410A in a horizontal smooth tube: Experiments and new correlations analyzing the effect of the reduced pressure
R Mastrullo, AW Mauro, JR Thome, D Toto, GP Vanoli
International Journal of Heat and Mass Transfer 55 (5-6), 1519-1528, 2012
812012
A chart for predicting the possible advantage of adopting a suction/liquid heat exchanger in refrigerating system
R Mastrullo, AW Mauro, S Tino, GP Vanoli
Applied Thermal Engineering 27 (14-15), 2443-2448, 2007
792007
Multi-criteria (thermodynamic, economic and environmental) analysis of possible design options for residential heating split systems working with low GWP refrigerants
F Botticella, F De Rossi, AW Mauro, GP Vanoli, L Viscito
International Journal of Refrigeration 87, 131-153, 2018
782018
Flow boiling heat transfer, dry-out vapor quality and pressure drop of propane (R290): Experiments and assessment of predictive methods
G Lillo, R Mastrullo, AW Mauro, L Viscito
International Journal of Heat and Mass Transfer 126, 1236-1252, 2018
712018
Modeling and optimization of a shell and louvered fin mini-tubes heat exchanger in an ORC powered by an internal combustion engine
R Mastrullo, AW Mauro, R Revellin, L Viscito
Energy conversion and management 101, 697-712, 2015
702015
Carbon dioxide local heat transfer coefficients during flow boiling in a horizontal circular smooth tube
R Mastrullo, AW Mauro, A Rosato, GP Vanoli
International Journal of Heat and Mass Transfer 52 (19-20), 4184-4194, 2009
662009
Experimental investigation on the performance of a transcritical CO2 heat pump with multi-ejector expansion system
G Boccardi, F Botticella, G Lillo, R Mastrullo, AW Mauro, R Trinchieri
International Journal of Refrigeration 82, 389-400, 2017
592017
Flow boiling of R32 in a horizontal stainless steel tube with 6.00 mm ID. Experiments, assessment of correlations and comparison with refrigerant R410A
G Lillo, R Mastrullo, AW Mauro, L Viscito
International Journal of Refrigeration 97, 143-156, 2019
552019
Carbon dioxide heat transfer coefficients and pressure drops during flow boiling: Assessment of predictive methods
R Mastrullo, AW Mauro, A Rosato, GP Vanoli
international journal of refrigeration 33 (6), 1068-1085, 2010
542010
Thermo-economic optimization of a multi-source (air/sun/ground) residential heat pump with a water/PCM thermal storage
F Pelella, G Zsembinszki, L Viscito, AW Mauro, LF Cabeza
Applied Energy 331, 120398, 2023
522023
Comparison of experimental pressure drop data for two phase flows to prediction methods using a general model
AW Mauro, JM Quibén, R Mastrullo, JR Thome
International Journal of Refrigeration 30 (8), 1358-1367, 2007
462007
Replacement of R404A with propane in a light commercial vertical freezer: A parametric study of performances for different system architectures
R Mastrullo, AW Mauro, L Menna, GP Vanoli
Energy Conversion and Management 82, 54-60, 2014
452014
Seasonal performance assessment of sanitary hot water production systems using propane and CO2 heat pumps
M Tammaro, C Montagud, JM Corberán, AW Mauro, R Mastrullo
International Journal of Refrigeration 74, 224-239, 2017
432017
Optimal design of a light commercial freezer through the analysis of the combined effects of capillary tube diameter and refrigerant charge on the performance
A Pisano, S Martínez-Ballester, JM Corberán, AW Mauro
International Journal of Refrigeration 52, 1-10, 2015
422015
Transient model of a vertical freezer with door openings and defrost effects
R Mastrullo, AW Mauro, L Menna, A Palma, GP Vanoli
Applied energy 121, 38-50, 2014
422014
Critical heat flux: Performance of R1234yf, R1234ze and R134a in an aluminum multi-minichannel heat sink at high saturation temperatures
R Mastrullo, AW Mauro, JR Thome, GP Vanoli, L Viscito
International Journal of Thermal Sciences 106, 1-17, 2016
412016
Film thickness measurements for annular flow in minichannels: Description of the optical technique and experimental results
A Donniacuo, R Charnay, R Mastrullo, AW Mauro, R Revellin
Experimental Thermal and Fluid Science, 2015
412015
Het systeem kan de bewerking nu niet uitvoeren. Probeer het later opnieuw.
Artikelen 1–20