Abstract Al–Cu–Mg/B 4 Cp metal matrix composites with reinforcement of up to 20 wt% were
produced using the powder metallurgy technique. The effects of reinforcement ratio …

In this paper, six solid–liquid lubricating materials have been prepared based on two kinds
of liquid lubricants including perfluoropolyethers oil (PFPE) and chlorinated-phenyl and …

Press molding of silicon (Si)/high-density polyethylene (HDPE) composite is an important
technology for producing thin hybrid infrared (IR) optics with microstructures. In this …

Some newly coated carbon fibers were prepared and used as reinforcement in epoxy matrix
for the fabrication of unidirectional composites. The carbon fibers were coated with …

In situ filling raises a possibility to restrain the agglomeration of nanomaterials in
macromolecule matrices, which usually is encountered in the nanocomposites prepared by …

Nanoparticles could improve the mechanical properties of polymer based composites due to
synergy of higher filler-matrix interaction and better load transfer from matrix to the fillers …

Excellent biocompatibility and biotribological performance are necessary for artificial
acetabular cups in total hip replacement. Herein, polytetrafluoroethylene (PTFE) …

Hydroxyapatite fiber (HAF) was fabricated via a one-step hydrothermal route by using urea
(CA), acetamide (AA) and propanamide (PA) as pH regulators, respectively, and the reaction …

A polymer additive blended with commercial engine oil to have enhanced film-forming ability
has been developed and studied using optical interferometry. An experimental study was …

Design and Study of Epoxy Composites based on Polycaprolactone and Nanodiamond
Functionalized Carbon Fibers Page 1 Ivy Union Publishing | http: //www.ivyunion.org ISSN …