[HTML][HTML] Grain crushing in geoscience materials–Key issues on crushing response, measurement and modeling: Review and preface
Grain crushing is commonly encountered in deep foundation engineering, high rockfill dam
engineering, railway engineering, mining engineering, coastal engineering, petroleum …
engineering, railway engineering, mining engineering, coastal engineering, petroleum …
DEM analysis of monotonic and cyclic behaviors of sand based on critical state soil mechanics framework
A series of monotonic and cyclic triaxial shearing tests on Toyoura sand are simulated by
discrete element method (DEM) incorporating rolling resistance. The input parameters are …
discrete element method (DEM) incorporating rolling resistance. The input parameters are …
Cyclic behaviour and resistance of saturated sand under non-symmetrical loading conditions
J Yang, HY Sze - Géotechnique, 2011 - icevirtuallibrary.com
This paper reports findings from an experimental study that aimed to investigate the
undrained behaviour of sand in non-symmetrical cyclic loading, and to clarify the role of …
undrained behaviour of sand in non-symmetrical cyclic loading, and to clarify the role of …
Quantifying and modelling fabric anisotropy of granular soils
This paper describes an integrated study of the effects of fabric anisotropy on granular soil
response, in which the microscopic measurements are properly linked with the macroscopic …
response, in which the microscopic measurements are properly linked with the macroscopic …
Shear wave velocity and stiffness of sand: the role of non-plastic fines
J Yang, X Liu - Géotechnique, 2016 - icevirtuallibrary.com
Current knowledge on the shear wave velocity (V s) and associated stiffness (G 0) of sand is
built mainly on the results of extensive laboratory studies on clean quartz sands. Often …
built mainly on the results of extensive laboratory studies on clean quartz sands. Often …
Dilatancy and shear strength of sand at low confining pressures
Sand dilates with shearing at a rate that increases with increasing relative density (DR) and
decreases with increasing effective confining stress (σ c′). The peak friction angle of a sand …
decreases with increasing effective confining stress (σ c′). The peak friction angle of a sand …
Effect of gradation on the strength and stress-dilation behavior of coarse-grained soils in drained and undrained triaxial compression
Geotechnical engineering practice commonly estimates the properties and behavior of well-
graded soils using methods and relationships developed based on the behavior of clean …
graded soils using methods and relationships developed based on the behavior of clean …
Effect of initial fabric from sample preparation on the mechanical behaviour of a carbonate sand from the South China Sea
T Yao, W Li - Engineering Geology, 2023 - Elsevier
Mega reclamation projects have been undertaken on the coral reefs. However, research on
the geotechnical properties of the hydraulically filled carbonate sand is limited, and the …
the geotechnical properties of the hydraulically filled carbonate sand is limited, and the …
The critical state friction angle of granular materials: does it depend on grading?
J Yang, XD Luo - Acta Geotechnica, 2018 - Springer
Whether the critical state friction angle of granular materials depends on grading is a
fundamental question of both academic and practical interest. The present study attempts to …
fundamental question of both academic and practical interest. The present study attempts to …
Strength and deformation of rockfill material based on large-scale triaxial compression tests. II: Influence of particle breakage
Y **ao, H Liu, Y Chen, J Jiang - Journal of Geotechnical and …, 2014 - ascelibrary.org
The amount of particle breakage of Tacheng rockfill material (TRM) in the process of
shearing was quantitatively measured by a relative breakage index. The fractal dimension of …
shearing was quantitatively measured by a relative breakage index. The fractal dimension of …