Metal cutting fluids (MCFs) under flood conditions do not meet the urgent needs of reducing
carbon emission. Biolubricant-based minimum quantity lubrication (MQL) is an effective …

The tribological behavior of cutting is a decisive factor in changing the production cycle, cost,
and quality of parts. Minimum quantity lubrication (MQL) based on environmentally friendly …

The most important aspect of sustainability in manufacturing is the preservation of energy
and natural resources. For modern production, optimized processes that minimize negative …

Nanofluids are efficient heat transfer media that have been developed over the past 27
years and have been widely used in the electronic microchannel, engine, spacecraft …

Today, superalloys (also known as hard-to-cut materials) such as nickel, titanium and cobalt
based cover a wide range of areas in engineering applications. At the same time …

The industrial sector's linear model of production and consumption has caused significant
environmental degradation, resource depletion, and waste generation. In response …

Products made of titanium and its alloys are widely used in modern areas like the
mechanical engineering, instrument making, aerospace and medical sector. High strength …

Nanofluid minimum quantity lubrication (NMQL) is a green processing technology.
Cottonseed oil is suitable as base oil because of excellent lubrication performance, low …

The poor thermal conductivity of Inconel 718 leads to higher cutting temperatures and, as a
consequence, rapid tool degradation is a common phenomenon. As a result, a hybrid lubri …

In this study, effects of drilling parameters and cryogenic treatment, which were applied to
the cutting tool (M35 HSS drill bit), on the burr width, surface roughness (Ra), chip formation …