Over the past few decades, aluminium (Al) has been considered to be beneficial for
castability but detrimental for the creep resistance of magnesium (Mg) alloys. However, an …

Porosity plays an important role in determining the ductility in magnesium alloy high
pressure die castings. In this work, X-ray Tomography (XRT), fractographic analysis and …

X-ray tomography was used to characterize the porosity in high pressure die casting of
AM60B alloy. In situ tensile deformation was performed to observe the change of porosities …

This paper describes the application of X-ray tomography to predict the tensile fracture
properties of aluminium alloy die-castings containing natural casting defects. A new …

The porosity induced by the externally solidified crystals (ESCs) in high pressure die casting
of AM60B magnesium alloy was investigated. Attention was focused on the formation of the …

Aluminum–silicon alloys are commonly used in die-cast and additively manufactured (AM)
light-weight components due to their good processability and high strength-to-weight ratio …

The aim of this study was to identify the effects of aluminum content and strain rate on the
compressive strain hardening behavior of AZ31, AZ61 and AZ91D cast magnesium alloys …

The failure behavior of high pressure die casting AZ91D magnesium alloy during both
tensile and fatigue tests was studied in situ by using scanning electron microscope. Attention …

The influence of melt flow in the gating system on microstructure and mechanical properties
of high pressure die casting AZ91D magnesium alloy was investigated. Experimental and …

The deformation and fracture behavior of die-casting aluminium (Al) alloys is very complex.
Due to local variations in properties, the microstructure and mechanical behavior of …