Deformation-induced austenite to martensite transformation is an important phenomenon
during the deformation of metastable fully austenitic transformation induced plasticity (TRIP) …

An appropriate fraction of a second phase for controlling the dynamic grain growth of the fine-
grained microstructure during hot deformation can be easily achieved for the high and …

The effect of grain size on the mechanical properties of an equiatomic CoCrFeNiMn high-
entropy alloy (HEA) was investigated by shear punch testing (SPT) as a miniature test …

In the present work, the mechanical anisotropic behavior of low-carbon (Fe–0.07 C) steel
processed by asymmetric cold rolling was investigated. Three different types of dynamic …

In this research, the experimental investigation of the change of the strain path on the
microstructure, mechanical properties and the forming limit diagram of Al/Mg two-layer sheet …

In this research, the effect of strain path and short-term post-annealing on the microstructure,
texture, and mechanical anisotropy of low-carbon steel was investigated. Asymmetric …

Since cross rolling promotes the transformation of austenite to deformation-induced α΄-
martensite and increases the dislocation density in the retained austenite, the reversion …

Shear cutting is a high-speed forming process where material separation is involved. The
nature of the process leads to high strain rates and temperatures on the sheared zone of the …

In present work, tensile behaviors of cold-rolled 304L stainless steel were investigated at
both room temperature (RT) and liquid nitrogen temperature (LNT). After cold-rolling with a …

The effects of cold rolling routes followed by annealing on the mechanical properties of AISI
316L stainless steel were characterized. Both unidirectional and cross rolling methods were …