The high temperature mechanical performance of Al–Si alloys can be enhanced by alloying
with transition metals, induced by the formation of thermally stable and coarsening resistant …

The thermo-mechanical fatigue (TMF) behaviors and corresponding damage mechanisms of
Al-Si piston alloy were investigated in the temperature ranges of 120–350° C and 120–425° …

The effects of ultrasonic melt treatment (UST) on the microstructure and mechanical
properties of Al-12.2 Si-3.3 Cu-2.4 Ni-0.8 Mg-0.1 Fe (wt%) piston alloy were systematically …

The influences of temperature on the microstructure evolution, tensile properties, especially
low-cycle fatigue (LCF) behaviors and damage mechanisms of Al-Si piston alloy have been …

Microstructures and mechanical properties of T7 heat-treated Al-5.0 Cu-0.6 Mn-1.0 Fe alloys
with different Ni content prepared via squeeze casting were studied using tensile testing …

As one of the lightweight and wear-resistance metallic structural materials, cast Al–Si alloys
have been widely studied in automobile and defense industries to meet the greater …

The effect of T6 heat treatment on microstructure evolution and mechanical properties of a
multi-component hot-rolled (HR) Al–Cu alloy were studied by scanning/transmission …

In order to study the effects of ε-Al 3 Ni phase on elevated temperature properties, Al-12Si-
0.9 Cu-0.8 Mg-xNi alloys with Ni contents of 1.0%, 2.5% and 4.0%, respectively, were …

Abstract The influence of Sr, Mg and Cu content on the microstructure of a high-pressure die
cast AlSi9Cu3 (Fe) alloy is reported. Metallographic and image analysis techniques have …

The thermo-mechanical fatigue (TMF) behaviors and corresponding damage mechanisms of
Al-Si piston alloy were investigated in the temperature range of 120~ 425° C under different …