There are several facets of aluminum when it comes to sustainability. While it helps to save
fuel due to its low density, producing it from ores is very energy-intensive. Recycling it shifts …

This paper presents a novel calibration procedure of the modified Mohr-Coulomb (MMC)
fracture model by use of localization analyses and applies it for three tempers of an AA6016 …

In this study, an in situ-generated ZrB 2 nanoparticle-reinforced AA6111 composite was hot
rolled to different reduction ratios in the range from 65% to 95% and characterized to …

In this article, a new age-hardening model for Al-Mg-Si alloys is presented (named NaMo-
Version 2), which takes into account the combined effect of cold deformation and prolonged …

In the present study, the various literature based on the high strain rate behaviour of the
ultrafine-grained (UFG) aluminium alloys produced through severe plastic deformation …

The structures of atomic clusters and GP-zones preceding precipitation in an Al-0.70 Mg-
0.85 Si-0.15 Fe-0.25 Mn (wt.%) alloy have been investigated by annular dark field scanning …

Deformation behavior of AA2099 Al–Li alloy containing Al 3 Li (δ′) precipitates at room
temperature has been systematically investigated via uniaxial compression experiments …

The present work is conducted to study microstructure and mechanical properties of as-cast
6016 Al alloy modified with Sc or/and Ge. Thermodynamic calculation, composition analysis …

The mechanical properties, texture and microstructural evolution of a 6111 aluminum alloy
during hot rolling and cold rolling deformation were systematically investigated in this article …

We analyse flow stress, work hardening and plastic anisotropy of two heat-treatable Al alloys
of the AA 6xxx and AA 7xxx series in dependence on state and morphology of the age …