In this study, machining parameters were evaluated and optimized with grey relational
analysis in drilling B 4 C reinforced metal matrix composites (MMCs) produced by powder …

The automotive industry is constantly striving for targets for the development of lightweight
materials for less fuel consumption and carbon emissions. For this purpose, lighter and …

In this study, the impacts of Cu and Si additions to Zn-40Al alloy on its microstructural,
mechanical and machinability properties were investigated in the turning process. Zn-40Al …

In this work, the research efforts have been made to investigate the effect of important drilling
parameters such as spindle speed and feed rate on effectiveness of process and quality of …

Abstract An Al‐12Si‐0.1 Sr alloy ingot was manufactured using a permanent mold casting
technique. The microstructure and mechanical properties of this alloy were researched …

In the current study, an effect of cryogenic treatment on the ageing of a B4C particulate
reinforced 7075 aluminium alloy was investigated to identify changes in hardness with …

In this study, the effects of strontium (Sr) and magnesium (Mg) elements in certain rates
added to Al-9Si alloy manufactured using permanent mold casting technique on the …

In this study, the microstructural, mechanical and machinability properties of Al-7Si-Mg and
Al-7Si-0.6 Mg casting alloys were experimentally researched. While the microstructures of …

Non-contact measurements of machining temperatures were performed with optical
pyrometer when drilling particle (B 4 C) reinforced metal matrix composites (MMCs) with …

In this study, Al-30Zn alloy was produced by permanent mold casting method. Drilling tests
were performed after the values of hardness, tensile strength and elongation to fracture of …