A complete understanding of 'cyclic plasticity induced transformation'of austenitic stainless
steels is documented in this article through different experiments, their critical analysis and …

Formation and nucleation mechanisms (ie γ→ ε, γ→ α′, γ→ deformation twins→ ε→ α′
and γ→ ε→ α′) of deformation-induced martensite (DIM) have been studied through …

Grain boundary engineering has revealed significant enhancement of material properties by
modifying the populations and connectivity of different types of grain boundaries within the …

Abstract 304LN stainless steel samples are tested in room temperature under low cycle
fatigue (LCF), ratcheting, pre-ratcheting followed by LCF and tensile, and pre-LCF followed …

Abstract A 304L-VAR stainless steel is mechanically characterized in tension over a full
range of strain rates from low, intermediate, to high using a variety of apparatuses. While low …

Room temperature tensile test results of solution annealed 304 stainless steel at strain rates
ranging between 5× 10− 4 and 1× 10− 1 s− 1 reveal that with increase in strain rate yield …

The incremental sheet forming (ISF) process is considered as a feasible solution for forming
a variety of small batch and even customised sheet components. The quality of an ISF …

The tensile properties of nanocrystalline 304 stainless steel plate (NSSP-304) produced by
severe rolling technology and its conventional polycrystalline 304 stainless steel (CPSS …

Utilizing transformation-induced plasticity (TRIP) steel with strain-induced martensitic
transformation (SIMT) on automotive steel plates and develo** products which have …

Ductile fracture behaviors of AISI304 stainless steel were investigated under different LSP
impact time when the strain rate varied from 1× 10− 4s− 1 to 0.1 s− 1 during the tensile test. It …