The hardness test is considered one of the easiest mechanical tests in terms of preparing its
specimens, as it does not need machining, unlike the tensile test that needs special …

The present article addresses solidification parameters, and includes analyses of the
macrostructure and microstructure in the light of the results obtained from the thermal …

The results of studies on the effect of the charge composition on the structure and
mechanical properties of cast aluminum alloys of the Al–Si–Mg (AK9ch) and Al–Mg (AMg6l) …

An increase in the sum of alloying elements in industrial silumins causes the formation of
excess intermetallic phases in their structure. When introducing modifiers in such alloys …

A comparative study on the influence of fabrication methods of AlTi4 master alloys on the
grain size of Al 3 Ti intermetallic compounds is performed. It is found that an increase in the …

Increasing of the amount of alloying elements in the industrial silumins causes the formation
of the structure of excess intermetallic phases. When incorporated in such alloys modifiers …

Аннотация Выполнено сравнительное исследование по влиянию способов получения
модифицирующих лигатур AlTi4 на размеры интерметаллидов Al3Ti. Установлено, что …

Аннотация Представлены результаты исследований по влиянию состава шихты на
структуру и механические свойства литейных алюминиевых сплавов систем Al–Si–Mg …

From the metallurgical and material science perspective, grain refinement is the reduction in
the size of the grains inside a material which enhances wear, toughness, formability, yield …

An increase in the sum of alloying elements in industrial silumins causes excess
intermetallic phases to form in their structure. When the amount of modifiers introduced into …