An in-band full-duplex radio receiver with a passive vector modulator downmixer for self-interference cancellation

DJ van den Broek, EAM Klumperink… - IEEE journal of solid …, 2015 - ieeexplore.ieee.org
In-band full-duplex (FD) wireless, ie, simultaneous transmission and reception at the same
frequency, introduces strong self-interference (SI) that masks the signal to be received. This …

A 0.4–6 GHz receiver for cellular and WiFi applications

H Razavi, B Razavi - IEEE Journal of Solid-State Circuits, 2022 - ieeexplore.ieee.org
A wideband RF receiver employs a multi-loop architecture to ease the tradeoff between
noise and linearity, a new method of harmonic rejection that relaxes gain and phase …

Analysis and design of low-power continuous-time delta-sigma modulator using negative-R assisted integrator

MH Jang, C Lee, Y Chae - IEEE Journal of Solid-State Circuits, 2018 - ieeexplore.ieee.org
The opamp in the integrators of a continuous-time delta-sigma modulator (CTDSM) has
stringent noise and linearity requirements, which lead to large power dissipation. In this …

1.3 Analog CMOS from 5 micrometer to 5 nanometer

W Sansen - 2015 IEEE International Solid-State Circuits …, 2015 - ieeexplore.ieee.org
In our future, as usual, analog designers will continue to expand their expertise and
knowledge in response to changing needs. While devices will change their nature and …

A switched-capacitor RF front end with embedded programmable high-order filtering

Y Xu, PR Kinget - IEEE Journal of Solid-State Circuits, 2016 - ieeexplore.ieee.org
We propose a switched-capacitor radio-frequency (RF) front end achieving an equivalent
high-order, tunable, highly linear RF filtering to improve the out-of-band (OB) blocker …

19.2 A self-interference-cancelling receiver for in-band full-duplex wireless with low distortion under cancellation of strong TX leakage

DJ van den Broek, EAM Klumperink… - 2015 IEEE International …, 2015 - ieeexplore.ieee.org
In-band full-duplex (FD) wireless communication, ie simultaneous transmission and
reception at the same frequency, in the same channel, promises up to 2x spectral efficiency …

Reconfigurable receiver with radio-frequency current-mode complex signal processing supporting carrier aggregation

R Chen, H Hashemi - IEEE Journal of Solid-State Circuits, 2015 - ieeexplore.ieee.org
A software-defined radio receiver that is suitable for intra-band carrier aggregation is
demonstrated. The RF front-end frequency selectivity is enhanced by the combination of the …

A baseband-matching-resistor noise-canceling receiver with a three-stage inverter-only OpAmp for high in-band IIP3 and wide IF applications

AN Bhat, RAR van Der Zee… - IEEE journal of solid-state …, 2020 - ieeexplore.ieee.org
In this article, we propose a baseband noise-canceling receiver architecture to increase in-
band linearity. A key feature of the architecture is that all active circuits are in baseband …

Analysis and design of a 20-MHz bandwidth, 50.5-dBm OOB-IIP3, and 5.4-mW TIA for SAW-less receivers

G Pini, D Manstretta, R Castello - IEEE Journal of Solid-State …, 2018 - ieeexplore.ieee.org
A power-efficient transimpedance amplifier with wide channel bandwidth is proposed to
meet the stringent linearity requirements of surface acoustic wave-less frequency-division …

A baseband-matching-resistor noise-canceling receiver architecture to increase in-band linearity achieving 175MHz TIA bandwidth with a 3-stage inverter-only …

AN Bhat, R van der Zee, S Finocchiaro… - 2019 IEEE Radio …, 2019 - ieeexplore.ieee.org
In this paper we propose a baseband noise-canceling receiver architecture to increase in-
band linearity. Key feature of the architecture is that all active circuits are in baseband …