Formation of nanograined structure and decomposition of supersaturated solid solution during high pressure torsion of Al–Zn and Al–Mg alloys

BB Straumal, B Baretzky, AA Mazilkin, F Phillipp… - Acta Materialia, 2004 - Elsevier
Structure and phase composition of five binary Al–Zn and Al–Mg alloys were studied before
and after high pressure torsion (HPT) with a shear strain 300. The grain size of (Al) solid …

Structural and optical properties of hot wall deposited CdSe thin films

S Velumani, X Mathew, PJ Sebastian… - Solar energy materials …, 2003 - Elsevier
Cadmium selenide (CdSe) films were prepared by hot wall deposition technique using
optimized tube length under a vacuum of 6mPa on to well-cleaned glass and ITO substrates …

Optical constants of vacuum‐evaporated polycrystalline cadmium selenide thin films

U Pal, D Samanta, S Ghorai… - Journal of applied physics, 1993 - pubs.aip.org
The optical constants (n, K) of vacuum‐evaporated polycrystalline CdSe thin films are
determined over 900–3100 nm photon wavelengths. Variation of band gap and optical …

Optical characterization of vacuum evaporated cadmium sulfide films

U Pal, R Silva-Gonzalez, G Martinez-Montes… - Thin solid films, 1997 - Elsevier
The optical constants (n, k) of cadmium sulfide (CdS) thin films were determined in the
spectral range of 0.55 μm to 1.80 μm from the optical absorption and transmittance …

Optical and electrical properties of BaTiO3 thin films prepared by chemical solution deposition

R Thomas, DC Dube, MN Kamalasanan, S Chandra - Thin solid films, 1999 - Elsevier
Barium titanate sol was prepared using barium ethyl hexanoate and titanium isopropoxide.
The sol was then spin coated on p-type single crystal silicon (100) wafers, stainless steel …

Study of ZnTe thin films deposited by rf sputtering

H Bellakhder, A Outzourhit, EL Ameziane - Thin Solid Films, 2001 - Elsevier
ZnTe thin films were prepared by cathodic rf-sputtering from a single high purity ZnTe target.
The deposition rate increases with sputtering power. The ZnTe films deposited at 50 W were …

Investigation of optical and electrical properties of different compositions of as-S-Se thin films at thickness 725 nm with high precision using a wedge-shaped optical …

A Qasem, ER Shaaban, MY Hassaan… - Journal of Electronic …, 2020 - Springer
Different compositions of as-obtained As 40 S 60-x Se x thin films (x= 0 at.%, 20 at.%, 40
at.%, and 60 at.%) with fixed thicknesses were deposited by a thermal evaporation …

Studies on the structural, microstructural and optical properties of sol–gel derived lead lanthanum titanate thin films

S Bhaskar, SB Majumder, M Jain, PS Dobal… - Materials Science and …, 2001 - Elsevier
The La modified lead titanate Pb1− xLaxTi1− x/4O3 (PLT)(x= 0.0, 0.05, 0.10, 0.15, 0.20, 0.25
and 0.30) thin films were deposited on sapphire (0001) substrates by the sol–gel process …

Electrodeposition and characterization of Fe doped CdSe thin films from aqueous solution

S Thanikaikarasan, K Sundaram, T Mahalingam… - Materials Science and …, 2010 - Elsevier
Thin films of Cadmium selenide (CdSe) and Ferrous (Fe) doped Cadmium selenide (CdSe:
Fe) have been deposited on indium doped tin oxide coated conducting glass (ITO) …

Optical and structural properties of two-sourced evaporated ZnTe thin films

AKS Aqili, Z Ali, A Maqsood - Applied Surface Science, 2000 - Elsevier
Optical properties of ZnTe films, deposited by thermal evaporation of Zn and Te sources,
were studied in the range of 400–2000 nm by UV–VIS–NIR spectrophotometer. Variations of …