This study introduces the improvement of mathematical and predictive models of surface
roughness parameter (Ra) in milling AA6061 alloy using carbide cutting tools coated with …

The aim of this study was to optimize machining parameters to obtain the smallest average
surface roughness (Ra) and flank wear (Vb) values as a result of the surface milling of a …

In this work, Ti 1-x Al x N (TiAlN) coatings were synthesized by low pressure chemical
vapour deposition (LPCVD), and the influence of a rotational precursor gas supply on the …

Low emission (Low-e) films are widely used in modern architectural glass. In this
presentation, spectroscopic ellipsometry (SE) between 1.12 and 2.75 eV (wavelength range …

Titanium alloy chemical milling wastewater contains a significant amount of ethylene glycol
monobutyl ether (EGBE), which is toxic and difficult to be degraded by microorganisms, and …

To explore the strengthening mechanism of the laser texturing process on the surface of
composite coating (AlCrN/AlTiSiN) cemented carbide and improve the application rate of …

High-quality and high-efficiency cutting technology for Ti6Al4V has rapidly developed, but is
still limited by many problems such as high cutting temperature and fast tool wear during the …

This work studied the simultaneous effect of multiple parameters on the microstructure and
topography of TiN thin films deposited by reactive unbalanced DC magnetron sputtering …

The deformation of thin-walled parts based on the lightweight Mg–Li alloy materials caused
by machining-induced stress is an important factor hindering the further development of …

This study investigates the optimization of machining performance for aluminum metal matrix
composites (Al-MMC) through real-time monitoring using temperature sensors and a …