[HTML][HTML] A review on additive manufacturing and materials for catalytic applications: Milestones, key concepts, advances and perspectives
Catalysis, a driving force of the chemical industry is increasingly being influenced by
additive manufacturing. The link between them is based on the need to intensify catalytic …
additive manufacturing. The link between them is based on the need to intensify catalytic …
Critical review of metal-ceramic composites fabricated through additive manufacturing for extreme condition applications
Metal-Ceramic composites are a special class of materials, including elements as matrix and
reinforcements. These composites, especially metal matrix composites, are of great …
reinforcements. These composites, especially metal matrix composites, are of great …
Mechanical properties of Al2O3 and Al2O3/Al interpenetrated functional gradient structures by 3D printing and melt infiltration
S Li, G Wang, K Zhang, X Zhang, L Zhang… - Journal of Alloys and …, 2023 - Elsevier
In this paper, Al 2 O 3 functional gradient structures (FGS) were prepared by digital light
processing-based 3D printing, and Al 2 O 3/Al interpenetrated FGS was subsequently …
processing-based 3D printing, and Al 2 O 3/Al interpenetrated FGS was subsequently …
[HTML][HTML] State-of-the-art research progress and challenge of the printing techniques, potential applications for advanced ceramic materials 3D printing
Y Wang, T Wu, G Huang - Materials Today Communications, 2024 - Elsevier
Traditional ceramic manufacturing is typically done using molds or by hand, which limits the
design complexity, and reduces production efficiency. Ceramic 3D printing technology …
design complexity, and reduces production efficiency. Ceramic 3D printing technology …
Metal additive manufacturing for load-bearing implants
Additive manufacturing (AM) has seen a remarkable evolution during the last three decades.
AM gained attention due to its ability to manufacture complex structures in a single operation …
AM gained attention due to its ability to manufacture complex structures in a single operation …
Preparation of fully dense boron carbide ceramics by Fused Filament Fabrication (FFF)
Boron carbide is the third hardest material known, with a high melting point (2450° C) and
poor sintering ability. Therefore, boron carbide is a challenging material for sha** by …
poor sintering ability. Therefore, boron carbide is a challenging material for sha** by …
Characterization of aluminum and boron carbide based additive manufactured material for thermal neutron shielding
We characterize the suitability of two additive manufactured materials for use in shielding
thermal neutrons for neutron scattering instrumentation. We compare two different boron …
thermal neutrons for neutron scattering instrumentation. We compare two different boron …
Microstructure and properties of additively-manufactured WC-Co microlattices and WC-Cu composites
Liquid ink-printing followed by sintering is used to fabricate WC-Co microlattices and cutting
tools. The microstructure of WC-xCo (x= 0.5-20 wt.%) is studied for a range of carbide-to …
tools. The microstructure of WC-xCo (x= 0.5-20 wt.%) is studied for a range of carbide-to …
Direct ink writing of boron carbide monoliths
Direct ink writing–an extrusion-based additive manufacturing process–followed by
pressureless sintering was investigated to produce boron carbide monoliths. The effects of …
pressureless sintering was investigated to produce boron carbide monoliths. The effects of …
Comparison of the effects of Mg and Zn on the interface mismatch and compression properties of 50 vol% TiB2/Al composites
HY Yang, ZJ Cai, Q Zhang, Y Shao, BX Dong… - Ceramics …, 2021 - Elsevier
Low ductility limits the extensive application of high volume fraction (> 30 vol%) ceramic
particle-reinforced metal matrix composites, and the simultaneous improvement of strength …
particle-reinforced metal matrix composites, and the simultaneous improvement of strength …