Diamond-reinforced metal matrix composites (DMMC) prepared by cold spray are emerging
materials simultaneously featuring outstanding thermal conductivity and wear resistance. In …

This study focuses on primary impurities, called intermetallics, in the microstructure of Al-Si-
X alloys, their formation, effects and treatments to eliminate or ameliorate their deleterious …

Abstract Al-7.3 Zn-2.2 Mg-2Cu alloy is known for its high strength, achieved because of
higher alloying concentration. However, the higher alloying concentration presents …

AA7068 is classified as high strength aluminum alloy and is primarily utilized in wrought
conditions which can be achieved with hot deformation. The process of hot deformation is a …

Hot compression is an efficient and widely accepted route for optimizing the microstructural
characteristics of metallic materials; thus, understanding hot deformation response is …

The features of microstructure formation and properties of commercial pure aluminum alloy
(Al 99.5%) obtained by radial-shear rolling (RSR) method at the different heating …

The hot band of CC AA 3003 aluminum alloy was cold-rolled to different reductions, and
then annealed at 482° C for 1 h under different pressures. The evolution of microstructure …

The work involves finite element analysis (FEA) and experimental investigation of formability
and geometrical accuracy prevailing in single point incremental forming (SPIF) process …

The twist channel angular pressing (TCAP) method was developed with the aim to increase
the effectiveness of severe plastic deformation (SPD) technologies. This study was focused …

The hot band of CC AA 3105 aluminum alloy sheets underwent 6 h of preheating treatment
at 599° C. Then, it was cold-rolled to various reductions, followed by 1 h of annealing at 482° …