Many research works report the use of LCL filters for grid-interfaced PV systems. Indiscreet
selection of passive LCL filter parameters may result in poor filtering and increased power …

An LCL‐filter draws much attention in grid‐connected applications, but the design faces
challenges. The LCL and controller parameters are interdependent and inter‐restricted as …

As a result of global energy demand increase, concerns over global warming, and rapid
exhaustion of fossil fuels, there is a growing interest in energy system dependence on clean …

This research paper proposes a novel grid-connected modular inverter for an integrated
bidirectional charging station for residential applications. The system is designed to support …

In microgrids (MG) with a high penetration of renewable energy sources (RES) power
converters are used to regulate the produced energy to a single voltage and frequency …

Owing to the inherent characteristics of grid‐side inverters, a minimum dc‐side voltage limit
usually exists in grid‐connected inverters. To solve this problem, this study proposes a …

Recently, LCL has become amongst the most attractive filter used for gridconnected flyback
inverters. Nonetheless, the switching of power devices in the inverter configuration creates …

Both the spectral analysis and the closed‐form root‐mean‐square (RMS) equations are
widely used to determine the three‐phase inverter dc‐link current for capacitor rating …

In this study, power quality (PQ) improvement has been addressed, in the form of total
harmonic distortion (THD) minimisation, as well as, voltage regulation using two cascaded …

A battery energy storage system (BESS), due to its very fast dynamic response, plays an
essential role in improving the transient frequency stability of a grid. The performance of the …