There are several facets of aluminum when it comes to sustainability. While it helps to save
fuel due to its low density, producing it from ores is very energy-intensive. Recycling it shifts …

Fundamentals of Aluminium Metallurgy: Recent Advances updates the very successful book
Fundamentals of Aluminium Metallurgy. As the technologies related to casting and forming …

The impact of the Cu/Li ratio on the sequence and kinetics of solid-state precipitation is
studied for two recently developed Al–Cu–Li–Mg–Ag alloys: AA2198 and AA2196. A …

Microstructure of deformed DMLS-AlSi10Mg under quasi-static loading was studied using
TEM to elaborate the strengthening mechanisms. In addition to Orowan (due to presence of …

A recurrent challenge with aluminum alloys is their longstanding trade-off between
mechanical strength and formability. Recently recyclability has put further pressure on the …

Additive manufacturing (AM) is an emerging technology capable of producing near net
shape structures in a variety of materials directly from a computer model. Standard metallic …

Abstract DMLS or Direct Metal Laser Sintering is a technique which can be classified under
an additive manufacturing (AM). In this technique, metal powders are used to manufacture …

Three-dimensional atom probe analysis is employed to characterize the Sc segregation at
θ′/α-Al interfaces in Al–2.5 wt.% Cu–0.3 wt.% Sc alloys aged at 473, 523 and 573K …

The paper reports a significant improvement in tensile properties, in particular at 200° C, of
commercial 2219 Al alloy by addition of small amounts of Sc (0.8 wt%) and Mg (0.45 wt%) …

Abstract α-Al grains surrounded by Al-Si eutectic as the substructures in AlSi10Mg alloy
fabricated by selective laser melting (SLM) were investigated in detail using three …