The atomic layer thermopile (ALTP) heat flux sensor has played an important role in the
study of boundary layer transition. However, the response characteristics of the sensors still …

Multilayer Ca3Co4O9 (349) thick thermoelectric (TE) materials were fabricated by hot-
pressing stacked dense and strongly textured single-layer samples. Microstructure and …

CuCr 1− x Mg x O 2 (x= 0 and 0.02) epitaxial thin films were prepared on 5/10 vicinal cut α-Al
2 O 3 (000l) substrates using pulsed laser deposition. The laser-induced thermoelectric …

The efficient preparation of inclined La 1-x Ca x MnO 3 (LCMO) films with excellent light-
induced transverse thermoelectric (LITT) performance on c-axis miscut 12° SrTiO 3 single …

In this work, pulse laser detectors based on the transverse thermoelectric effect of
YBa2Cu3O7-δ thin films on vicinal cut LaAlO3 (001) substrates have been fabricated. The …

Ultrafast transverse thermoelectric voltage response has been observed in c‐axis inclined
epitaxial La0. 5Sr0. 5CoO3thin films. Voltage signals with the rise time of 7 ns have been …

La 1− x Sr x CoO 3 (0.05≤ x≤ 0.4) thin films with tilted c-axis have been grown on vicinal
cut LaAlO 3 (100) substrates by pulse laser deposition. The single phase and the epitaxial …

Abstract Ca 3 Co 4 O 9+ δ thin films were prepared on 5° vicinal cut LaAlO 3 (001)
substrates by pulsed laser deposition and subsequently annealed at various temperatures …

The development of high-performance optically induced voltage materials represents a
significant challenge within the realm of optical detection. The constraints posed by low …

A sol-gel methodology is employed to prepare Bi2212 thin films on single crystal LaAlO 3
miscut substrates with nominal tilt angles of 0°, 5°, 10°, and 15°. The study focuses on …