During the past thirty years, two generations of low alloy steels (ferrite/pearlite followed by
bainite/martensite) have been developed and widely used in structural applications. The …

Tensile/impact behaviour of lower bainite obtained in high-Si steel 55Si3Mn2CrMoVNb was
studied using SEM, TEM, and XRD. Specimens were austenitized at 900◦ C and …

In this work, the effect of holding durations (10–60min) during austempering at 300, 350 and
400° C on the structure and properties of a 0.61 C-1.71 Si-0.86 Mn steel has been studied …

Herein, the microstructure and mechanical properties of a high‐carbon bainitic steel treated
by long‐time bainitic austempering and short‐time austempering plus tempering processes …

The mechanical properties and wear resistance of the ultrafine bainitic steel austempered at
various temperatures were investigated. Scanning electron microscopy (SEM) and X-ray …

Outstanding mechanical properties of nanostructured carbide-free hard bainitic steels, also
known as super bainite, with microstructural constituents of less than 100 nm thicknesses …

The effect of isothermal heat treatment temperatures under martensite start (Ms) temperature
on the microstructure and mechanical properties of high-silicon commercial spring steel has …

A series of austempering processes above and below the martensite start temperature (Ms)
were employed to evaluate the effect of various austempering temperatures on bainite …

The microstructure evolution in Co-based alloy/AISI 410 stainless steel dissimilar welded
joints by aging at 566° C for 200, 400, 600, and 800 h was systematically investigated. In …

The mechanical properties and wear resistance of the ultra-fine bainitic steel austempered
at various temperatures were investigated. Scanning electron microscopy (SEM) and X-ray …