This paper describes the results of an experimental and numerical investigation of the
impact behavior of short carbon fiber reinforced polyether-ether-ketone (SCFR PEEK) …

It is a common industrial practice to eject injection-molded plastic parts early, at a high
temperature, and allow the parts to cool down in the air. This practice shortens the cycle time …

The injection molding process of non-pneumatic tires is a crucial step in ensuring high-
quality product and performance. To improve the quality of non-pneumatic tire processing …

In the present era, the importance of simulations pertaining to production is increasing in
terms of cost, human resources, and time. As the majority of existing studies on polymer …

Plastics reinforced by natural fibers attract growing attention, particularly in the automotive
industry. The properties and performance of these composites are usually determined …

To optimize the strength design of short-fiber injection molding components, a three-
dimensional flow and structural analysis simulations were employed. In particular, these …

This study addresses the effects of injection moulding weld lines and fibre orientation
distributions on the mechanical properties of short fibre-reinforced thermoplastics (SFT). In …

Short fiber reinforced polymer composites (SFRPC) produced by injection molding process
have established a commercial utilization in all sectors due to low cost and lower weight of …

Lif takviyeli plastik malzemeler ürün hafifletme çalışmalarında kullanılan kompozit
malzemelerdendir. Anizotropik yapıda olan bu malzemelerin enjeksiyon prosesinde, akışa …

Powertrain mounts' purpose is to mount the engine and the gearbox in the car. Besides that,
it isolate the body from the powertrain movements and road excitation. The most common …