The tape casting process for manufacturing low‐temperature co‐fired ceramic green sheets: a review

L Ren, X Luo, H Zhou - Journal of the American Ceramic …, 2018 - Wiley Online Library
For low‐temperature co‐fired ceramic technology, the fabrication of high‐performance green
sheet is a critical step because of its effect on subsequent operations such as punching …

Effect of molar ratio on the microstructure, dielectric and multiferroic properties of Ni0.5Zn0.5Fe2O4-Pb0.8Zr0.2TiO3 nanocomposite

R Xu, Z Wang, R Gao, S Zhang, Q Zhang, Z Li… - Journal of Materials …, 2018 - Springer
In the present work, Ni 0.5 Zn 0.5 Fe 2 O 4/Pb 0.8 Zr 0.2 TiO 3 nanocomposite with different
molar ratio (1: 2, 1: 3, 1: 5, 1: 7) was prepared by hydrothermal method and sol–gel method …

Materials that can replace liquid electrolytes in Li batteries: Superionic conductivities in Li1. 7Al0. 3Ti1. 7Si0. 4P2. 6O12. Processing combustion synthesized …

E Yi, W Wang, S Mohanty, J Kieffer, R Tamaki… - Journal of Power …, 2014 - Elsevier
We demonstrate that liquid-feed flame spray pyrolysis (LF-FSP) processing provides non-
aggregated nanopowders that can be used immediately to tape cast, producing thin films (< …

[HTML][HTML] Structural, electric and magnetic properties of multiferroic Ni0. 6Mg0. 4Fe2O4+ BaZr0. 2Ti0. 8O3 composites

P Chavan - Results in Chemistry, 2023 - Elsevier
Abstract Magnetoelectric (ME) composites (x) Ni 0.6 Mg 0.4 Fe 2 O 4)+(1-x)(BaZr 0.2 Ti 0.8 O
3) were synthesized by using solid state reaction technique, followed by uniaxial pressing …

Piezoelectric transducers for assessing and monitoring civil infrastructures

YK An, MK Kim, H Sohn - Sensor technologies for civil infrastructures, 2014 - Elsevier
Piezoelectric transducers are being commonly used for sensing and actuation applications
for smart structural systems. In particular, they are widely used for structural health …

Dispersion of nano-sized BaTiO3 powders in nonaqueous suspension with phosphate ester and their applications for MLCC

LW Chu, KN Prakash, MT Tsai, IN Lin - Journal of the European Ceramic …, 2008 - Elsevier
The stability of nano-sized BaTiO3 nonaqueous suspension with different phosphate ester
surfactants was investigated. Among the three phosphate esters (mono-alkyl, di-alkyl and …

The effects of nanoparticle addition on SiC and AlN powder–polymer mixtures: Packing and flow behavior

VP Onbattuvelli, RK Enneti, SJ Park, SV Atre - International Journal of …, 2013 - Elsevier
The development of methods to increase sintered density and improve dimensional
tolerances is a crucial issue in powder metallurgy and ceramic processing. Increasing the …

Optimization of process parameters for the production of Ni–Mn–Co–Fe based NTC chip thermistors through tape casting route

MN Muralidharan, EK Sunny, KR Dayas… - Journal of alloys and …, 2011 - Elsevier
Ni–Mn–Co–Fe–O based ceramic compositions were prepared and their NTC thermistor
characteristics were evaluated. The tape casting slurry composition was optimized to get …

Tape casting of nanocrystalline ceria gadolinia powder

LP Meier, L Urech, LJ Gauckler - Journal of the European Ceramic Society, 2004 - Elsevier
A ceramic ceria gadolinia solid solution membrane for solid oxide fuel cells was fabricated
by tape casting using a nanopowder of 37nm average particle size. A novel combination of …

Single-crystalline Bi5O7NO3 nanofibers: hydrothermal synthesis, characterization, growth mechanism, and photocatalytic properties

S Yu, G Zhang, Y Gao, B Huang - Journal of colloid and interface science, 2011 - Elsevier
A new photocatalyst, namely single-crystalline Bi5O7NO3 nanofibers, was prepared by a
facile hydrothermal method in the presence of Triton X-100 and ammonia. Bi5O7NO3 …