Microwave (MW) dielectric ceramics are used in numerous electronic components for
modern wireless communication systems, including antennas, resonators, capacitors and …

Dense microwave dielectric ceramics of Ce2 [Zr1− x (Al1/2Ta1/2) x] 3 (MoO4) 9 (CZMAT)(x=
0.02–0.10) were prepared by the conventional solid-state route. The effects of (Al1/2Ta1/2) …

Two novel low-ε r gallates MGa 2 O 4 (M= Ca, Sr) have been synthesized via a standard
solid-state reaction method. According to the X-ray diffraction results, CaGa 2 O 4 …

Cold sintering is adopted to pre-densify LiF ceramics, where the relative density increases
significantly from 72.1% at 125 MPa to 88.9% at 500 MPa. The following post-annealings at …

In this study, high-entropy spinel-type (Mg 0.2 Co 0.2 Ni 0.2 Li 0.4 Zn 0.2) Al 2 O 4 ceramics
were synthesized by solid-state reaction method. The raw materials gradually formed spinel …

In this work, a series of (1-x) MgAl 2 O 4-xMg 2 TiO 4 (expressed as (1-x) MA-xMT)(0.0≤ x≤
0.9) ceramics were successfully prepared via a solid-state reaction, and the effect of Mg 2 …

Ceramics that are thermally conductive and can be sintered at low temperatures are
particularly desired for hybrid integration and co-fired technology in upsurging high …

SrF 2 is a promising low-ε r fluoride with outstanding microwave dielectric properties, while
densification of SrF 2 ceramics is challenging via traditional thermal sintering (TTS). In this …

A novel low-ε r Zn 3 Ga 2 SnO 8 ceramic was prepared, and the phase composition and
microstructural evolution were investigated. According to Rietveld refinement, TEM, and …

BaF 2 is a low-firing fluoride with excellent microwave dielectric properties, while the
densification of BaF 2 ceramics is challenging via conventional sintering. In this work, dense …