Metallurgical defects significantly affect the performance of materials fabricated by selective
laser melting (SLM), becoming a bottleneck problem in the application of laser 3D printing …

The effects of the pH value on the electrodeposition process of Fe–P alloys from a ferrous
sulfate bath with sodium hypophosphite as the phosphorus source are investigated. The …

The tensile deformation behavior of columnar-grained Fe–6.5 wt.% Si alloy with< 100> fiber
texture at intermediate temperatures (300–500° C) was investigated. Compared with …

Optimization of 3D printing parameters was studied for the difficult to print, brittle Fe-6.5 wt%
Si, applying powder bed fusion (PBF) technology. Printing orientation, volumetric energy …

Introduction of alloying elements into interface is proven effective in improving bonding
strength of the A2/Cu interface, which improves surface quality of silicon steel strip in the …

Melt spinning method has been widely applied for fabrication of Fe‐based amorphous/
nanocrystalline ribbons in industry. Compared with Fe‐based amorphous/nanocrystalline …

Abstract Fe-6.5 wt% Si steel samples of different thicknesses (1 mm, 2 mm, and 5 mm) were
prepared by arc-melting and suction-casting with sub-rapid solidification rates. The …

The growing trend of large power and high frequency in electromagnetic conversion
applications urges advancements in the saturation magnetization (M s), effective …

This chapter describes different rapidly solidified processing routes of soft magnetic alloys
and their properties and applications in different areas. Section-2 explains the details of …

Additive Manufacturing (AM) of electric motors, specifically, Laser Powder Bed Fusion
(LPBF), for rotating soft magnetic cores is of research interest because of its potential …