Carbon nanotubes (CNTs) were used as reinforcements in the TiCuZrNi brazing alloy for
joining C/C composites to Ti6Al4V. The effects of CNTs content on the shear strength and …

C/C composites and Ti 6 Al 4 V sheets were joined using a novel Cu/TiCuZrNi composite
braze and the effect of Cu foil thickness on the microstructure and mechanical properties of …

Unidirectional carbon fiber reinforced epoxy was tested in ambient air at three different
levels of relative humidity and under full immersion in demineralized water. Reciprocating …

The main goal of this study is to investigate the do** effects of carbon nanotubes (CNTs)
and graphene on the needle-punched carbon/carbon (C/C) composites that are prepared by …

An attempt has been undertaken to obtain a better understanding of the friction and wear
mechanisms of C/C composites by microstructural analysis of the friction surface layer and …

2D carbon/carbon (C/C) composites have been successfully joined by partial transient liquid
phase (PTLP) bonding using Ti–Ni–Si compound as interlayer. The shear strengths of C/C …

Carbon/carbon (C/C) composite joints were successfully prepared using Ti–SiC–Si–C
compound as filler by vacuum hot-press technique. The effects of interlayer thickness and …

This work describes experimental studies on the effect of running-in on the tribological
properties of friction carbon–carbon (C/C) composite materials used in the production of disc …

Partial transient liquid phase (PTLP) bonding has been successfully developed to join
carbon/carbon (C/C) composites using Ti–Ni–Al2O3–Si compound as interlayer. Gradient …

Drilling is one of the costliest and risky activities in oil and gas industry due to complexity of
interactions with downhole formation. Under such conditions, the uncertainty of drillstring …