Ti6Al4V alloy is successfully used as implant material in dental and orthopedic surgeries for
years due to its much better compatibility, lower density, corrosion resistance, etc. compared …

In this study, ZrCu-based thin films were obtained using a PVD-cathodic arc technique,
aiming to improve the surface properties of 316L stainless steel and Ti6Al4V implant …

The current research aim is to biofunctionalize pure titanium (Ti, grade IV) substrate with
titania nanotubes and Zn doped hydroxyapatite-based coatings by applying a duplex …

In the field of orthopaedic implants, post-surgery infections and biocompatibility are the most
challenging obstacles. Sustained and controlled antibiotic release is a key factor in novel …

In this study, micro-and nanosurface structures were fabricated by sandblasting (S), acid-
etching (E), anodic oxidation (A), sandblasting/acid-etching (SE), sandblasting/anodization …

Biomaterials are an important and integrated part of modern medicine, and their
development and improvement are essential. The fundamental requirement of a biomaterial …

Introduction The lack of osteoinductive, angiogenic and antimicrobial properties of
hydroxyapatite coatings (HA) on titanium surfaces severely limits their use in orthopedic and …

Osteoblastic and chemical responses to Poly (ether ether ketone)(PEEK) material have
been improved using a variety of low-temperature plasmas (LTPs). Surface chemical …

Orthopaedic implants for load-bearing applications are usually composed of titanium-based
materials. Aiming to propose a strategy able to improve the bone-implant interface on these …

In this brief review, porous and non-porous biomaterials used as scaffolds in regenerative
medicine and tissue engineering and new innovative techniques to obtain biomaterials were …