In the present work, copper metal matrix composites (CuMMCs) were developed using the
electric resistance sintering (ERS) technique. Micro-particles of silica sand (5 wt%) and …

Ti–Ni matrix composites were produced using spark plasma sintering (SPS), a powder
metallurgy technique. The influence of Ni-xTiB 2 additions on the titanium matrix …

Unlocking the full potential of intermetallic TiAl alloys in aerospace and automotive engines
demands critical attention, as their limitations, particularly due to the room temperature brittle …

The synthesis of x-wt.%(where x= 2.5, 5, 7.5, and 10) TiB2-reinforced titanium matrix was
accomplished through the spark plasma sintering technique (SPS). The sintered bulk …

The nanohardness, elastic modulus, anti-wear, and deformability characteristics of TiAl
(100− x)-x TaN composites containing 0, 2, 4, 6, 8, and 10 wt.% of TaN were investigated via …

Four titanium composites with varying titanium diboride contents of approximately 2.5 wt%, 5
wt%, 7.5 wt%, and 10 wt% were developed using the powder metallurgy technique. The …

Currently, one of the most important problems is water scarcity due to increasing population
and environmental factors. Humankind can overcome this problem by recycling polluted …

Titanium matrix composites were manufactured using pulsed plasma sintering with the
addition of 5 wt.% Ni and TiB2 (x= 5, 10, 15, 20 wt.%) particles at a sintering temperature of …

The mechanical mixing of dinickel boride and aluminium powders was achieved with a
Turbula mixer. The admixed powders were fabricated via the spark plasma sintering …

The synthesis of dinickel boride (2.5 wt.% and 7.5 wt.%) reinforced with titanium matrix was
achieved using the spark plasma sintering. The characterization of the sintered samples was …