Cobalt catalysts supported on metal oxides (ZrO2, CeO2, SiO2, Al2O3, and TiO2) were
prepared to investigate the effects of the support for the preferential oxidation (PROX) of CO …

Hex-element AlxCoCrCuFeNi (x= 0.5, 1, 2) metallic and oxide films were deposited by
sputtering homogeneous alloy targets in argon and argon–oxygen plasma, respectively. The …

Thermal behaviour of pure ferric nitrate, ammonium molybdate and their mixtures in different
ratios were investigated by means of thermal analysis (TG, DTG and DTA) techniques …

The influence of CO pretreatment on the properties of CuO/CeO2/γ-Al2O3 catalysts was
investigated using X-ray diffraction (XRD), temperature programmed reduction (TPR), X-ray …

A series of Cu/SiO 2 catalysts with copper loadings ranging from 17.8 to 42.2 wt% were
prepared by the sol–gel method and evaluated for the hydrogenolysis of diethyl oxalate to …

In this work, DFT simulation method was used to study the adsorption and dehydrogenation
of ethanol on Cu/Cr 2 O 3 catalyst. Firstly, the stable configuration of Cu 4 cluster adsorbed …

The effects of method of preparation of CuO–NiO system on its surface, textural and catalytic
properties were investigated. The system investigated was prepared by four different …

Copper oxide and niobium pentoxide were supported on silica–alumina with 2, 5, 10, 15
and 25 mass% loadings and 1: 1 mass ratio of CuO: Nb 2 O 5. XRD and BET measurements …

In-situ synthesis of photocatalytic CuAl 2 O 4 –Cu hybrid nanorod arrays - Chemical
Communications (RSC Publishing) DOI:10.1039/B903865E Royal Society of Chemistry View …

Nanosized CuO, Mn2O3 and a mixture of both oxides supported on cordierite were
prepared by wet impregnation followed by calcination at 350–700° C. The prepared …