In any metal cutting machining operation, the cutting fluid plays important role by cooling the
cutting tool and the surface of the work piece, also chips are removed from heat affected …

This study focused on using the Taguchi technique to optimize the process parameters in
drilling of AISI D2 steel with carbide drills to minimize the surface roughness (Ra) and thrust …

Al2O3 with 13 and 45wt.% TiO2 microsized powders (6–22 and 13–41μm for each chemical
composition) were used as raw materials to coat AISI 1040 steel by atmospheric plasma …

Machinability study on drilling of green austempered ductile iron (ADI) grade was conducted
using a TiAlN-coated tungsten carbide drill. The green ADI grade was produced by a novel …

This research investigates the mechanical properties of a Cr–Ni–Mo‐alloyed rock drill steel
tempered at different temperatures from 150 to 550° C. The highest strength, hardness, and …

In the present study, the influence of nickel content on the machinability of a prehardened
hot-work tool steel was investigated. The machinability with varying nickel content from 1 to …

Cu–Zn alloys (brass) are widely used as industrial materials because of their excellent
characteristics such as a balance of strength and ductility, high corrosion resistance, non …

In this paper, high-strength brass (Cu–40% Zn) alloy with magnesium (Mg) element was
fabricated via powder technology process, and the effect of the additive Mg element on …

The effects of solid solutionizing treatment and following hot extrusion on microstructural and
mechanical properties of the extruded brass alloy (Cu-40Zn) with a small addition of titanium …

Se evaluó el efecto de afilado de la broca sobre la resistencia a la perforación de
recubrimientos de alúmina–óxido de titanio, obtenidos mediante proyección térmica por …