The effect of large-strain cold-to-warm deformation on the microstructures and mechanical
properties of various steels and alloys is critically reviewed. The review is mainly focused on …

The microstructural mechanisms providing delamination toughness in high-strength low-
alloyed steels are briefly reviewed. Thermo-mechanical processing methods improving both …

The twinning induced plasticity steel 0.6 C–18 Mn–1.5 Al (wt.%) employed in this study
exhibited a strength of about 1GPa, combined with a large uniform elongation of over 60% at …

In this study a novel micro-rolling set-up was installed on a directed energy deposition
additive manufacturing system to achieve in-situ grain refinement and porosity closure. A …

Solid-state additive friction stir deposition was employed to three dimensionally print a 316L
stainless steel. The microstructure, texture and grain boundary distribution were …

The austenite and ferrite microstructure evolution and softening mechanisms have been
investigated in a 21Cr–10Ni–3Mo duplex stainless steel, containing about 60% austenite …

The microstructure of Monel K500 alloy was investigated consisting of (Ni-Cu-Al) solid
solution matrix distributed with TiC precipitates. The semi-coherent interface was formed …

Hot compression experiments were conducted on 42CrMo steel under different conditions
using a Gleeble-3500 thermomechanical simulator. Systematic studies on the microstructure …

In this work, hot compression behaviors and deformation mechanisms of a Ni–Co-based
superalloy prepared using directional solidification (DS) were investigated by carrying out …

The effect of strain rate on dynamic recrystallization (DRX) behavior and mechanism of alloy
617B was investigated by isothermal compression test in a temperature range of 1393 K to …