Sliding mode control in power converters and drives: A review
Sliding mode control (SMC) has been studied since the 1950s and widely used in practical
applications due to its insensitivity to matched disturbances. The aim of this paper is to …
applications due to its insensitivity to matched disturbances. The aim of this paper is to …
DC shipboard microgrids with constant power loads: A review of advanced nonlinear control strategies and stabilization techniques
In modern dc shipboard microgrid (SMG) systems, the propulsion motors and hotel loads are
always supplied through tightly regulated point of load converters, which behave as constant …
always supplied through tightly regulated point of load converters, which behave as constant …
Review on advanced control technologies for bidirectional DC/DC converters in DC microgrids
DC microgrids encounter the challenges of constant power loads (CPLs) and pulsed power
loads (PPLs), which impose the requirements of fast dynamics, large stability margin, high …
loads (PPLs), which impose the requirements of fast dynamics, large stability margin, high …
A novel composite nonlinear controller for stabilization of constant power load in DC microgrid
Transportation electrification involves the wide utilization of power electronics based dc
distribution networks and the integration of a large amount of power electronic loads. These …
distribution networks and the integration of a large amount of power electronic loads. These …
Analysis and implementation of a new SEPIC-based single-switch buck–boost DC–DC converter with continuous input current
In this paper, a novel buck–boost dc–dc converter with continuous input current is proposed.
The voltage gain of the presented converter is higher than conventional converters, such as …
The voltage gain of the presented converter is higher than conventional converters, such as …
An offset-free composite model predictive control strategy for DC/DC buck converter feeding constant power loads
The high penetration of power electronic converters into dc microgrids may cause the
constant power load stability issues, which could lead to large voltage oscillations or even …
constant power load stability issues, which could lead to large voltage oscillations or even …
Adaptive backstep** sliding mode control for boost converter with constant power load
J Wu, Y Lu - IEEE Access, 2019 - ieeexplore.ieee.org
The negative impedance characteristics of a constant power load (CPL) can easily lead to
the instability of the DC bus voltage. To improve the stability of the DC bus voltage, an …
the instability of the DC bus voltage. To improve the stability of the DC bus voltage, an …
A decentralized power management strategy for hybrid energy storage system with autonomous bus voltage restoration and state-of-charge recovery
For hybrid energy storage system in dc microgrid, effective power split, bus voltage
deviation, and state-of-charge (SoC) violation are significant issues. Conventionally, they …
deviation, and state-of-charge (SoC) violation are significant issues. Conventionally, they …
Stationary-frame grid-forming inverter control architectures for unbalanced fault-current limiting
Grid-forming (GFM) control offers promising performance features for inverter-based
resources (IBRs) across scales. However, design, analysis, and benchmarking of GFM IBRs …
resources (IBRs) across scales. However, design, analysis, and benchmarking of GFM IBRs …
Review of dynamic and transient modeling of power electronic converters for converter dominated power systems
In response to national and international carbon reduction goals, renewable energy
resources like photovoltaics (PV) and wind, and energy storage technologies like fuel-cells …
resources like photovoltaics (PV) and wind, and energy storage technologies like fuel-cells …