Despite the obvious advantages of additive manufacturing (AM) in producing metallic parts,
defect formation remains a challenge that deleteriously impacts some critical materials …

Two X-ray computed tomography (CT) datasets have been acquired for a cold-sprayed
titanium sample before and after heat treatment. The datasets were collected with a beam …

In this study, a revised formulation based on the uniform strain method (Flanagan and
Belytschko, 1981) and the scaled boundary finite element method (SBFEM)—a numerical …

With the advancement of metal additive manufacturing (AM), lattice structures become a
promising solution to situations that require lightweight design and yet maintain adequate …

This article is intended as a tutorial guide for new users of the DCM (data-constrained
modelling) software for quantitative characterization of material 3D microstructures using …

Accurate determination of the dielectric properties of porous rocks is important for the
dielectric exploration methods in a range of applications from water resources to petroleum …

Atmospheric plasma spray (APS) deposited ceramic coatings of zirconium boride (ZrB 2)
and hydroxyapatite (HAp) were inspected using Data-Constrained Modelling (DCM) of X-ray …

Unlike many other clastic rocks, relating velocity and permeability to porosity for micrite-
bearing carbonate rocks has been largely unsuccessful. Recent studies have shown that …

The accurate evaluation of hydrate saturation, in marine sediments, not only can provide
references for hydrate resources assessment but also help to monitor hydrate …

The dissolution of metal sulfides, especially chalcopyrite and the development of porosity in
samples of two different low-grade ores during chloride leaching have been studied by …