In this work, we reviewed the available phase selection rules comprising atomic size and
topological aspects, entropies, enthalpies, melting points, valence and itinerant electron …

This review surveys rapid solidification (RS) processing of titanium alloys. The attributes of
and requirements for RS are discussed along with techniques of RS including powder, flake …

The effect of the melt-spinning processing variables such as wheel speed, gas ejection
pressure and melt temperature on cooling rates measured by a thermoelectric technique …

The effect of primary α-Fe precipitation on thermal properties and magnetic properties was
systematically investigated by fabricating Fe 76.5-x Cu 1 Nb x Si 13.5 B 9 (x= 0, 1, 2 and 3) …

Quasicrystal (QC) phases are often observed in Al-based alloys with Al content< 85 at%,
and their particle size is typically greater than 0.3 µm. In this study, an in situ formed QC …

Microstructures of melt spun hypomonotectic Al− 7wt% In, hypermonotectic Al− 5wt% Pb and
near monotectic Al− 2wt% Pb alloys have been examined by transmission electron …

We investigated novel pathways to improve the mechanical properties of liquid metallurgy
produced Fe–TiB 2 based high modulus steels (HMS) by controlled solidification kinetics …

Hypermonotectic alloys of Al-5 wt% Pb and Al-5 wt% Pb-0.5 wt% X where X= Mn, Cu, Zn, Fe
and Si have been manufactured by chill-casting and melt-spinning. The resulting …

Filled skutterudites are promising mid-to-high temperature range thermoelectric materials for
power generation, however, a traditional melt-solidification process followed by annealing …

Metallic glasses (MG) have attracted much attention due to their superior hardness and
good corrosion resistance. However, designing new MG compositions is still a big …