The improved interpretation of marine controlled source electromagnetic (CSEM) data
requires knowledge of the inter-relationships between reservoir parameters and low …

Foam flooding is an important method to enhance oil recovery after water flooding. In this
paper, a novel low interfacial tension (LIFT) nitrogen foam was successfully prepared by an …

Experimental data of resistivity index and oil-brine capillary pressure on sandstone and
carbonate rock samples from 4 reservoirs are reported. Laboratory equipment using actual …

We conducted a laboratory study of the joint elastic‐electrical properties of sixty‐three brine‐
saturated sandstone samples to assess the likely impact of differential pressure (confining …

Deep reservoirs are in a high-pressure and high-temperature (HPHT) environment, while
the experimental conditions for rock electrical properties that meet the deep reservoir …

Abstract Knowledge about the pressure dependency of elastic and electrical properties is
important for a variety of geophysical applications. We present a technique to invert for the …

Producing oil at a water cut higher than necessary has always been a preoccupation for
practising engineers. The existence of a critical rate above which excessive water …

Experimental results are presented for resistivity and permeability measurements on clay-
free sandstone and shaly synthetic rock samples at simulated reservoir conditions of …

The porous plate method was used to determine capillary pressure curves and saturation
exponents at ambient conditions and at full reservoir conditions (reservoir pressure …

We measured the electrical impedances of 22 sandstone samples during oil-driving-water
tests using the two-electrode method. Experiments show that the imaginary part X of the …