We report the observation of coexisting Bose-Einstein condensate (BEC) and Fermi gas in a
magnetic trap. With a very small fraction of thermal atoms, the 7 Li condensate is quasipure …

The energy converted to heat during high strain rate plastic deformation is measured directly
using an infra-red method for Ta− 2.5% W alloy and, indirectly, using UCSD's recovery …

The energy balance equation for elastoplastic solids includes heat source terms that govern
the conversion of some of the plastic work into heat. The remainder contributes to the stored …

The conversion of plastic work to heat at high strain rates gives rise to a significant
temperature increase which contributes to thermal softening in the constitutive response of …

The goal of this study is to analyze the effect of heat generation during plastic deformation in
new sheet steel with high strength on the mechanical behavior during relaxation test …

Magnesium alloys are an ideal candidate due to their low density in comparison to
aluminum and steel alloys when designing a vehicle with lower weight and therefore …

An improved calibration method for infrared radiometers is developed that has been shown
to increase the accuracy of temperature measurement. To validate this new calibration …

We present an experimental validation of the variational theory of thermo-mechanical
coupling of Yang et al.(2006) in the case of finite thermo-visco-plasticity. The variational …

We present a thermodynamic scheme to capture the variability of the Taylor–Quinney
coefficient in austenitic steels showing strain induced martensitic transformation at high …

Abstract The Taylor-Quinney coefficient (TQC) or the cold-work conversion factor is the
fraction of external work that is converted into heat during the plastic deformation of a …