A critical review on the progress of MQL in machining hardened steels
Due to their increased hardness, hardened steels are referred to as difficult-to-cut metals.
Machining such hardened steels (hard machining) is preferred since it minimizes process …
Machining such hardened steels (hard machining) is preferred since it minimizes process …
Investigation, modeling, and optimization of cutting parameters in turning of gray cast iron using coated and uncoated silicon nitride ceramic tools. Based on ANN …
A comparative study is undertaken in terms of the surface roughness criterion (Ra), the
tangential cutting force (Fz), the cutting power (Pc), and the material removal rate (MRR) in …
tangential cutting force (Fz), the cutting power (Pc), and the material removal rate (MRR) in …
Optimization of process parameters during turning of Inconel 625
SP Waghmode, UA Dabade - Materials Today: Proceedings, 2019 - Elsevier
One of the important machining technology is high speed machining, It is used for difficult to
machine materials like nickel base alloy, titanium etc. For grinding process important …
machine materials like nickel base alloy, titanium etc. For grinding process important …
ANN surface roughness optimization of AZ61 magnesium alloy finish turning: Minimum machining times at prime machining costs
Magnesium alloys are widely used in aerospace vehicles and modern cars, due to their
rapid machinability at high cutting speeds. A novel Edgeworth–Pareto optimization of an …
rapid machinability at high cutting speeds. A novel Edgeworth–Pareto optimization of an …
Theoretical roughness modeling of hard turned surfaces considering tool wear
Surface roughness is an important factor in metal cutting, and usually different surface
roughness characteristics are used to control the quality of the machined surfaces. However …
roughness characteristics are used to control the quality of the machined surfaces. However …
ANFIS based prediction and parametric analysis during turning operation of stainless steel 202
The paper deals with the parametric analysis and ANFIS-based modeling of process
parameters during turning operation of stainless steel 202. In this experimental work, the …
parameters during turning operation of stainless steel 202. In this experimental work, the …
Surface topography description after turning Inconel 718 with a conventional, wiper and special insert made by the SPS technique
This paper presents a comparison of surface morphology obtained after machining Inconel
718 by the conventional insert, by Wiper insert and by using the cutting insert made by Spark …
718 by the conventional insert, by Wiper insert and by using the cutting insert made by Spark …
Finite-element-analysis of the effect of different wiper tool edge geometries during the hard turning of AISI 4340 steel
L Jiang, D Wang - Simulation Modelling Practice and Theory, 2019 - Elsevier
This paper investigates the performance of different wiper tool edge geometries in
machining of AISI 4340 steel using finite element method (FEM) simulation. The cutting …
machining of AISI 4340 steel using finite element method (FEM) simulation. The cutting …
Experimental investigations on wiper inserts' edge preparation, workpiece hardness and operating parameters in hard turning of AISI D2 steel
Review of the available literature indicates that hard part turning requires tailored cutting
edge for specific tool workpiece combination. Incidentally, much work could not be found …
edge for specific tool workpiece combination. Incidentally, much work could not be found …
Experimental investigation of process parameters on surface roughness and dimensional accuracy in hard turning of EN24 steel
Hard turning is the process of cutting hardened components with hardness ranging from 45
to 70 HRC within the 2-µm range. Hard turning differs from traditional turning in the sense …
to 70 HRC within the 2-µm range. Hard turning differs from traditional turning in the sense …