A low-cost low-power baseband processor for passive UHF RFID Tag based on EPC C1G2
protocol is presented in this paper. In order to minimize the power consumption, a novel …

The integration of strong security functionality to radio-frequency identification (RFID) tags
operating in the ultra-high frequency (UHF) range is challenging. Main limiting factors are …

This paper describes the design of mixed-signal back end for an ultrahigh-frequency sensor-
enabled radio-frequency identification transponder in full compliance with the Electronic …

Adaptive routing is once again becoming of interest because of the possibility to couple on-
line probing in networks with real-time dynamic and distributed control of paths and flows …

In this paper, a RFID baseband processor designed according to the EPC C1G2 protocol is
presented. By adjusting the processor's activities according to the RF modulated envelop …

A passive UHF RFID tag's baseband processor design with energy-aware structure is
presented in this paper, based on EPC C1G2 protocol. For the consideration of limited …

Abstract A long range UHF RFID tag suitable for battery-less wireless sensors is
implemented. The main theoretical limitations involving maximum communication distance …

Based on deep submicron CMOS technologies and limit power availability, a low-power
subthreshold passive UHF RFID tag's digital design is presented in this paper. The design …

Passive UHF RFID transponders (tags, in short) are mixed-signal Systems-on-Chip (SoCs)
for remotely powered communications which must comply with stringent requirements on …

A low-voltage wide-tolerance-range passive UHF RFID tag's baseband logic design is
presented in this paper. Based on deep submicron CMOS technologies, the design utilizes …