This study aims to provide a review of the literature on the hybrid reinforced concrete beam-
column joints that used steel fibers reinforced concrete (SFRC) or high-performance fibers …

The paper presents a comprehensive review on shear strength provisions of RC beam–
column joint in various national codes viz. ACI 318-2014, NZS 3101-1: 2006, EN 1998-1 …

Beam-column joint design for reinforced concrete (RC) buildings is a critical issue for
modern earthquake engineering, because for these structural elements, the current codes …

Four sets of exterior-beam-column subassemblies with and without construction joint (cold
joint) in column to simulate multistage casting at site were tested under cyclic loading …

The beam-column joints are very restricted areas in which the internal forces, generated by
boundary elements, act on the concrete core and reinforcing bars with a very high gradient …

This study investigates structural behaviors of reinforced concrete (RC) moment frame
connections strengthened using three different FRPs with different cross section …

Reactive powder concrete (RPC) is used in the beam-column joint region in two out of four
frames. Finite element modeling of all specimens is developed by using ABAQUS software …

An analytical and experimental investigation was conducted herein to examine the cyclic
load behavior of beam–column joint subassemblages, typical of both the modern reinforced …

Fly ash (FA) is a byproduct obtained after burning of coal in power plant as waste, however
considered as one of the building materials having reasonable binding properties. Indeed …

Fiber-reinforced cementitious composites have been increasingly used during recent years
on beam-column joints and the introduction of headed bars is a practical solution to …