In this paper, we systematically proposed the strategy of tailoring strain delocalization to
evade long-standing strength-ductility trade-off dilemma. The scientific contribution is to …

Since the 1960s, it has been a common practice worldwide to pursue a homogeneous
distribution of reinforcements within a matrix material, discontinuous metal matrix …

The yield strength of metals is typically governed by the average grain size through the Hall-
Petch relation, and it usually follows the rule of mixture (ROM) for layered composite …

The interactions between dislocations (dislocations and deformation twins) and boundaries
(grain boundaries, twin boundaries and phase interfaces) during deformation at ambient …

The mechanical properties and fracture characteristics of stainless steel clad plates by
vacuum hot rolling at different rolling temperature of 1100° C (S1), 1200° C (S2) and 1300° …

For the first time, vacuum carburization surface treatment was applied to high carbon
bearing steel 100Cr6. The rolling contact fatigue (RCF) life and the wear behavior of 100Cr6 …

In order to improve the intrinsic brittleness of TiAl alloys, Ti 2 AlNb alloys with outstanding
ductility and toughness at room temperature, and good high-temperature performance are …

The NiAl intermetallic compounds have higher service temperature and lower density than
traditional Ni-based super-alloy. In this work, for overcoming the fabricating bottleneck of …

Pearlitic steels are commonly used for railway rails because they combine good strength
and wear properties. During service, the passage of trains results in large accumulation of …

The local stress and strain are analyzed in a heterogeneous microstructure induced by
compression of aluminium rings under nearly full sticking conditions. This analysis is based …