Solid-state recycling, which involves the direct recycling of scrap metal into bulk material
using severe plastic deformation, has emerged as a potential alternative to the conventional …

Develo** high-strength Al-based alloys that can operate at 250° C and above remains a
challenge. In this study, a heat-resistant and high-strength (4TiC+ 5AlN)/Al–Fe–Mn …

In order to get higher heat resistance, microalloying elements like Cu, Si and Mn were
added to optimize the microstructure of AlN p/Al–Fe composites. After Mn addition, the Al–Fe …

The microstructural parameters in pure Nb, irradiated with 5 MeV proton beam have been
evaluated as a function of dose using X-ray diffraction line profile analysis. In order to assess …

Deformation microstructure of pure Ni powder milled for short duration was studied. The
microstructure, as obtained on the basis of Rietveld analysis and microstructural modeling …

The sapphire chemical mechanical polishing (CMP) process is complicated. The silicate
products such as Al 2 SiO 5 are produced during the polishing process. This paper applies …

α-Al2O3 prepared by combustion technique was ball-milled in a planetary ball-mill for
several hours. A detail microstructural characterization of the ball-milled samples was …

Nanocrystalline boron doped tin oxide and boron and silver co-doped SnO2 was
successfully prepared by using simple sol-gel method. The structural property of as …

Boron doped tin oxide nanocrystals with tetragonal symmetry (space group: P42/mnm) were
prepared by sol-gel route using three different polyhydroxy alcohols like starch, glycerol and …

A facile route was used to modify Al particle surfaces by putting Al particles into an Al (OH) 3
suspension, which was produced by the reaction of Al powder with water under vacuum at a …