Corrosion of heat exchanger materials in co-combustion thermal power plants

K Li, Y Zeng - Renewable and Sustainable Energy Reviews, 2022 - Elsevier
Co-firing biomass and fossil fuel offers an alternative way of reducing greenhouse gas
emission via adding CO 2-neutral biomass fuel into power generation systems. However …

[HTML][HTML] Scale-up challenges and opportunities for carbon capture by oxy-fuel circulating fluidized beds

S Seddighi, PT Clough, EJ Anthony, RW Hughes, P Lu - Applied Energy, 2018 - Elsevier
Oxy-fuel combustion is a promising technology for carbon capture and storage (CCS) from
large point sources. In particular, fluidized bed (FB) boilers represent one of the power …

Hot corrosion behavior of super alloys

G Prashar, H Vasudev - Materials Today: Proceedings, 2020 - Elsevier
In future industries like gas turbine engines, steam turbines and coal gasification will reach
new heights in terms of operating temperatures and efficiencies. These advancements in …

Effect of temperature on hot corrosion of nickel-based alloys for 700° C A-USC power plants

P Pan, T Li, Y Wang, N Zhang, H Chen - Corrosion Science, 2022 - Elsevier
Nickel-based alloys were exposed to a synthetic flue gas at varying temperatures from 700°
C to 800° C. Two main damage mechanisms were revealed, including general surface …

[HTML][HTML] Air quality estimation using remote sensing and GIS-spatial technologies along Al-Shamal train pathway, Al-Qurayyat City in Saudi Arabia

SS Al-Alola, II Alkadi, HM Alogayell… - Environmental and …, 2022 - Elsevier
Air pollution is the atmospheric state in which specific elements concentrations has adverse
impacts on human health as well as the environment including global warming …

Investigation on high temperature corrosion of water-cooled wall tubes at a 300 MW boiler

X **ong, X Liu, H Tan, S Deng - Journal of the Energy Institute, 2020 - Elsevier
Because of the updated requirement on ultra-low NOx emission (< 50 mg/Nm 3), most of
Chinese coal-fired boilers have to be operated at a low NOx combustion mode. However, for …

NOx and SO2 emissions of coals, biomass and their blends under different oxy-fuel atmospheres

W Moroń, W Rybak - Atmospheric Environment, 2015 - Elsevier
Co–firing biomass and coal under oxy-fuel combustion holds the potential for negative CO 2
emission into the atmosphere and is a promising technology to realized atmospheric CO 2 …

[HTML][HTML] Iron oxide fluxing and precipitation in sulphate deposits during heat-resistant alloy corrosion in simulated combustion gas

X **, J Zhang, B Gleeson, DJ Young - Corrosion Science, 2024 - Elsevier
Abstract Two ferritic alloys, Fe-25Cr and Fe-25Cr-2Mn-1Si, and two austenitic alloys, Fe-
25Cr-20Ni and 310SS, coated with a thin film of Na 2 SO 4-K 2 SO 4 mixture were exposed …

Mechanical investigations of astm a36 welded steels with stainless steel cladding

P Preedawiphat, N Mahayotsanun, K Sa-Ngoen… - Coatings, 2020 - mdpi.com
The in-service life of ASTM A36 welded steel pipes in power plants is often shortened by ash
corrosion. During the heating condition, the ash deposition on the welded steel pipes …

Effect of pre-oxidation on hot corrosion resistance of HR3C stainless steel in sulfate salt with or without Fe2O3

Z Yu, J Lu, M Chen, J Wang, F Wang - Corrosion Science, 2021 - Elsevier
HR3C steel exhibits high oxidation resistance in air at 700° C owing to the formation of a
dense chromia scale. In the presence of sulfate salt deposition (Na 2 SO 4: K 2 SO 4= 1: 1) …