Corrosion, more specifically, pitting corrosion happening extremely in marine environments,
leads to lifespan of materials drastically decreasing in service, which causes enormous …

The demand for robust engineering materials demonstrating good tribological performance
under arduous service conditions has forged the development of novel coating materials …

Ni–P multilayer coatings were deposited on the surfaces of low-carbon steel by direct
current electrodeposition through a stirring-time controlled technique (STT). The …

The influence of thermal diffusion treatment on the microstructure and corrosion behavior of
hot-dipped Al coated Fe− Cr− Si− B cast steel in a 5 wt.% NaCl solution was studied. The …

In this work, the effects of deposition potential,[Ni 2+]/[Zn 2+] molar ratio, pH and bath
temperature on the electrocrystallization mechanism of Zn single bond Ni alloy from an …

In this research, the ZnOG hybrid thin film was produced via solgel method. The surface
morphology, band gap and photoactive properties of the films were studied by means of …

Substrate protection coatings are widely applied in the industry. Zn–Ni alloys have less
potential for corrosion, thus preserving the steel substrate by corroding first. In this sense …

Nickel (Ni) single-layer coatings were electrodeposited under varying pulse periods (T), duty
cycles (θ), and average current densities (iav) using four distinct pulse current waveforms …

The effect of current density and bath temperature in the electroplating process on
resistance to corrosion of Zn-Ni alloys was evaluated in this work. The electrolytic bath …

M2052 is a famous high dam** Mn–Cu alloys with good strength, but lack of well
corrosion and wear resistance. In this study, we expect to enhance the wear and corrosion …