Lithium (Li) metal, as an appealing candidate for the next‐generation of high‐energy‐
density batteries, is plagued by its safety issue mainly caused by uncontrolled dendrite …

Boron oxide (B2O3) thin films were deposited on Si (100) substrates using a single source
precursor by thermal MOCVD method under a pressure of 150 mTorr and the temperature …

In this work, commercial LiCoO 2 is modified with a glassy B 2 O 3 by solution mixing with H
3 BO 3 followed by post-calcination in order to enhance its high-voltage electrochemical …

Abstract Lithium stannate (Li 2 SnO 3) has been prepared by solution evaporation method.
The precursor obtained is sintered at 800° C for 5, 6, and 7 h, respectively. X-ray …

Layer-structured LiTiO2 as a coating layer is built on the surface of ternary layered LiNi0.
5Co0. 2Mn0. 3O2 microspheres using a facile infiltrative pre-coating approach. The uniform …

Well dispersed ultrafine platinum nanoparticles (Pt NPs) loaded on pristine (p-CNOs) and
boron oxide modified carbon nano-onions (B-CNOs) were successfully synthesized by the …

CoWO 4 nanoparticles were synthesized by a facile sonochemical method. The formation of
wolframite type monoclinic structure was studied by XRD. Both SEM and TEM analyses …

Abstract Nanocrystalline LiB x Mn 2− x O 4 (x= 0.1–0.4) particles are prepared by ultrasonic
spray pyrolysis using lithium nitrate, manganese nitrate and boric acid at 800° C in an air …

Nanostructured cathodes materials have been playing a major role in the development of
alternative clean and sustainable energy technologies. There exist several review articles …

The objective of the present study is to investigate the effect of sintering temperature on the
structural, electrical and electrochemical properties of novel Mg 0.5 Si 2 (PO 4) 3 NASICON …