This paper reviews quantitative characterization via transmission electron microscopy (TEM)
and its application to interfacial phenomena based on the results obtained through the …

Abstract An Mg-Si-based 6082 aluminium metal matrix composite reinforced with varying
concentrations of CoCrFeMnNi high-entropy alloy particles (HEA p) was processed through …

A quantitative investigation on the influence of precipitation process and kinetics on the
Young's modulus evolution and strengthening mechanism of a Cu-1.95 wt% Be alloy is …

In this paper, the effect of the heat treatment process on mechanical properties is
systematically investigated, and the optimal aging process is obtained. Transmission …

The coherent strain caused by the different sizes of the nanoscale η'phases in Al–Zn–Mg–
Cu alloys was investigated via scanning transmission electron microscopy and geometric …

Recrystallization of a ball-milled ferritic ODS steel is studied towards its evolution from as-
milled powder to consolidated state. This characterization has been made possible by using …

Normally, the strength and formability of aluminum alloys can be increased largely by severe
plastic deformation and heat treatment. However, many plastic deformation processes are …

In the present work, the effect of artificial aging on the Cu-Mg co-clustering and mechanical
behavior in a pre-strained Al-Cu-Mg alloy are investigated by tensile and fatigue testing, X …

Abstract Strain maps for Nd 2 Fe 14 B grains in Nd–Fe–B sintered magnets, representing
elongation/contraction in the spacing of c planes, have been revealed by analyzing artificial …

Strain fields around the η′ phase precipitated in an Al-12Zn-2.4 Mg-1.1 Cu alloy were
quantitatively measured employing high-resolution transmission electron microscopy …