This review article summarizes the hot deformation behavior of high entropy alloys (HEAs)
and the corresponding constitutive description of flow stress. The potential of hot working for …

Hot working, as an important group of post-processing routes for additive manufacturing
technology (3D printing), is used to reduce the solidification/processing defects and …

The hot deformation behavior of Al-Mg-Si alloys was investigated by isothermal
compression tests in a temperature range from 400° C to 550° C and a strain rate range from …

The hot deformation behavior of a novel Sc, Zr alloyed Al-Zn-Mg-Cu alloy was explored in
the isothermal hot compression test with a temperature range of 300–500° C and a strain …

Constitutive equations were used to derive the flow stress of a 17–4 PH stainless steel
during hot compression testing. Two general methods were used:(i) a conventional method …

The hot deformation behavior of a medium carbon microalloyed steel was studied using the
hot compression flow curves corresponding to the temperature range of 850–1150° C under …

The hot working behaviour of additively manufactured Ti–6Al–4V pre-forms by Electron
Beam Melting (EBM) has been studied at temperatures of 1000–1200° C and strain rates of …

The dynamic recrystallization (DRX) of AISI 304 stainless steel was studied with torsion test
in the temperature range of 900–1100° C and the strain rate range of 5.0× 10− 2–5.0× 100 …

The hot deformation behavior of Al-Mg-Si alloy is studied based on diffusion mechanism.
The quantity of low angle grain boundaries increases rapidly, accompanied by the formation …

The influence of initial microstructure on discontinuous dynamic recrystallization (DDRX)
has been investigated by using high purity and ultra high purity austenitic stainless steels …