With production from gas/condensate reservoirs, the flowing bottomhole pressure of the
production well decreases. When the flowing bottomhole pressure decreases below the …

Sand or fine is a typical product in many processing of oil production from unconsolidated
and weakly consolidated formations. High variation of in situ stress, fluid production rate …

Condensate-to-gas ratio (CGR) plays an important role in sales potential assessment of both
gas and liquid, design of required surface processing facilities, reservoir characterization …

Well productivity in gas condensate reservoirs is reduced by condensate banking when the
bottom hole flowing pressure drops below the dew point pressure. Among the several …

Cyclic gas injection into gas condensate reservoir is regarded as an effective development
method to enhance condensate oil recovery. The aim of this work is to investigate the phase …

Added values to project economy from condensate sales and gas deliverability loss due to
condensate blockage are the distinctive differences between gas condensate and dry gas …

The recovery process of a rich condensate gas reservoir depends strongly on the phase
behavior properties of the reservoir fluid. In this study, three rich condensate gases (referred …

When the reservoir pressure is decreased lower than the dew point pressure in shale gas
condensate reservoirs, condensate would be formed in the formation. Condensate …

Methane injection or gas cycling is the recovery process of choice for gas-condensate
reservoirs. For economic reasons, however, this process can often not be implemented. An …

Gas injection has been used as a means of pressure maintenance in the secondary oil
recovery and in the tertiary oil recovery as Enhanced Oil Recovery (EOR) techniques. The …