This paper presents a new structure of an induction heater for aluminum parallelepiped
workpiece. The studied device uses a magnetic field created by a permanent magnet …

Induction heating of non-magnetic cylindrical billets is modeled. The billet rotates in static
magnetic field generated by appropriately distributed permanent magnets. The …

The heating process of aluminum billets requires controllable temperature distributions and
high efficiency. Compared with conventional ac induction heaters, the high temperature …

Purpose This work aims to study a new design of linear permanent magnet transverse flux
induction heating devices of nonmagnetic parallelepipedic workpiece. In these topologies …

Purpose This paper aims to develop a new quasi-three dimensional (3D) analytical model
devoted to the study of nonlinear transient magneto-thermal coupled problems in permanent …

Introduction to the Special Section on Induction Heating Systems Page 1 2504 IEEE
TRANSACTIONS ON INDUSTRIAL ELECTRONICS, VOL. 61, NO. 5, MAY 2014 Introduction …

In this work, the electromotive force (EMF) near a permanent magnet heating cylinder was
determined using a practical test bench. The aim is to elaborate three-dimensional analytical …

Mechanical properties of FRP such as strength and stiffness as well as the bonding interface
between FRP and concrete will be badly deteriorated when exposed to high temperature …

This paper aims to develop a new 3D analytical model devoted to the study of nonlinear
transient magneto-thermal coupled problems in permanent magnet transverse flux induction …

An alternative way of induction clam** is described, consisting in heating of the sleeve by
its rotation in static magnetic field generated by suitably arranged permanent magnets. The …