The CALPHAD technique is a powerful tool for materials processing and alloy design. The
quality of CALPHAD-type calculations is strongly dependent on the quality of the …

Conical pick is a widely used tool for cutting coal in mines. It has a cemented carbide tip
inserted in a steel body. Cemented carbide has been in use for many years for coal/rock …

To explore the impact of the sintering rate on the microstructure and mechanical properties
of cermets, the preparation of (Ti, W) C cermets by ultrafast sintering via spark plasma …

NiCrAl-40% WC coatings with different Ti mass fractions were prepared on H13 steel by
laser cladding (LC), in which the TiC was in-situ grew to enhance their tribological …

To improve the wear resistance of copper components, laser surface cladding (LSC) was
applied to deposit (Ti, W) C reinforced Ni–30Cu alloy composite coating on copper using a …

The interest in understanding the wear mechanisms of cemented carbide (CC) is not a new
development. For a long time, there have been studies on different wear mechanisms under …

In the present work, the thermal conductivities of two WC-Co-TiC cemented carbides, YT5
(85WC-5TiC-10Co, in wt%) and YT15 (79WC-15TiC-6Co), are measured from room …

The utilization of titanium aluminide (TiAl) alloys is widespread in the high-temperature
sectors of the aerospace industry, despite their challenging manufacturing process and …

The influence of Mn additions on the microstructure and magnetic properties of FeNiCr/60%
WC composite coatings produced by laser cladding was investigated. The microstructure of …

This study presents a novel approach for the synthesis of WC-Ni cemented carbides with
enhanced mechanical properties. A low-cost solution-based route was used to coat WC …