Wear leads to loss of functions of machines and to a decrease in their efficiencies.
Controlling wear through wear resistance tests is a very important task. Wear tests aim to …

Objective For many decades the failure of titanium implants due to corrosion and wear were
approached individually and their synergic effect was not considered. In recent past …

The microstructures, mechanical, corrosion, and wear behaviors of the Ti x ZrNbTaMo (x=
0.5, 1, 1.5, and 2, molar ratio) high entropy alloys (HEAs) were studied. It was found that the …

High entropy alloys (HEAs) show promise as materials for structural applications, even at
elevated temperatures. However, their wear behaviour over a wide range of temperatures …

Abstract Effects of Mo content on corrosion and tribocorrosion of Ti-(8–20) Mo alloys
fabricated by powder metallurgy (PM) were investigated. With a higher Mo content, the Ti-Mo …

Metals, ceramics, polymers, and composites have been employed in joint arthroplasty with
ever increasing success since the 1960s. New materials to repair or replace human skeletal …

The aim of this work was to study the influence of the processing route on the microstructural
constituents, hardness and tribological (wear and friction) behavior of Ti6Al4V biomedical …

This paper reviews the most recent available literature relating to the electrochemical
techniques and test procedures employed to assess tribocorrosion behaviour of passive …

The corrosion and tribocorrosion behaviour of SLM-produced Ti6Al4V alloy was studied in
comparison with its HP and commercial counterparts in 9 g/L NaCl solution at body …

In this study, the effects of Cu content on wear, corrosion, and tribocorrosion resistance of Ti-
10Mo-xCu alloy were investigated. Results revealed that hardness of Ti-10Mo-xCu alloy …